Captain Hook's hook prop (Hook, deals 1991 movie) raw 3D-printed kit

NOTE! READ BEFORE YOU BUY

This is a raw 3D-Printed kit. Supports and excess material is removed but for a perfect finish you need to sand and paint it yourself.
I will include an assembly guide and finishing tips with your order. Print is made from PLA (Either gray or silver)

*******************************************
Replica of Captain Hook's hook! Screen accurate to the film version. The hook comes off! Just twist it and you can replace it with whatever accessory you can imagine (Currently working on different toppers for the hook. Will post these as soon as they are ready). The hook also has a handle (already attached) on the inside, so just slide it on your arm and start swashbuckling!
Some assembly deals is required but instructions are included and takes about five minutes at most. I would recommend using super-glue to attach pieces together.
Print is made from gray PLA-plastic. Roughly 355mm (14 inches) tall, and weighs about 300 grams (10.5 oz). Inside diamater is about 90mm at it's narrowest, and 100 at its widest (3.5-3.9 inches).

The printed kit consists of:

-Top and bottom main part. Clicks together easily with wooden dowels (Included in kit) and seam is integrated into design.
-Cup portion.
-Hook. Needs to be glued to cup. Seperated for easier shipping but also invisible seam.
-Locking plate. A small plate with two threaded nuts inside. Use M3 screws to connect to main part. (Pre-attached before shipping)
-Hook locking rod. A T-shaped tube with a dowel. Used to lock the hook and cup in place. Tube is pre-cut to the correct lenght.